Our Chemicals
Browse our range of industrial and specialty chemicals
Showing 281–300 of 356 products
Sodium Acetate
Sodium acetate (CAS 127-09-3) is the salt behind reusable heat pads. A supersaturated solution stays liquid far below its freezing point, then crystallises on a trigger and releases the stored heat.
Sodium Benzoate
Sodium benzoate (CAS 532-32-1) is a vapour-phase and contact corrosion inhibitor for ferrous metals. In engine coolants and hydraulic fluids it passivates steel surfaces at low dose without the toxicity of chromate inhibitors.
Benzoic Acid
Benzoic acid (CAS 65-85-0) is used industrially as a chemical intermediate and corrosion inhibitor rather than as a preservative. It is the feedstock for phenol, caprolactam and benzoate plasticisers.
Potassium Benzoate
Potassium benzoate (CAS 582-25-2) delivers the same benzoate chemistry as the sodium salt without contributing sodium. It is specified where sodium would raise conductivity or interfere with the system being protected.
Potassium Carbonate
Potassium carbonate (CAS 584-08-7), potash, is the reagent behind the hot potassium carbonate process for removing carbon dioxide from industrial gas streams at high pressure and temperature.
Sodium Propionate
Sodium propionate (CAS 137-40-6) is the more soluble propionate salt, which suits liquid dosing and spray application. It is used where a calcium contribution would be unwanted or would disturb a formulation.
Ammonium Propionate
Ammonium propionate (CAS 17496-08-1) is supplied as a solution rather than a powder because it is deliquescent. It preserves high-moisture grain while contributing non-protein nitrogen that rumen microbes can use.
Calcium Acetate
Calcium acetate (CAS 62-54-4) is used industrially as a chloride-free concrete set accelerator, a phosphate binder, and the agent that gels alcohol into the solid fuel burned in chafing dish heaters.
Calcium Propionate
Calcium propionate (CAS 4075-81-4) is used industrially as a mould inhibitor in animal feed and stored grain. It also acts as a mild set retarder and corrosion inhibitor in concrete formulations.
Potassium Acetate
Potassium acetate (CAS 127-08-2) is the standard runway and aircraft de-icer. Unlike chloride de-icers it does not corrode aluminium airframes or attack the carbon brake assemblies that chlorides destroy.
Zinc Acetate
Zinc acetate (CAS 557-34-6) is a soluble zinc salt used as a crosslinker, mordant and wood preservative. Its solubility in both water and organic solvents sets it apart from the oxide and carbonate.
Sodium Dehydroacetate
Sodium dehydroacetate (CAS 4418-26-2, INCI Sodium Dehydroacetate) is a broad-spectrum cosmetic preservative that stays active at near-neutral pH, where benzoate and sorbate have largely stopped working.
Polyaluminium Chloride (PAC)
Polyaluminium chloride, PAC (CAS 1327-41-9), is a pre-hydrolysed aluminium coagulant. Because the hydrolysis is done during manufacture rather than in the water, it works across a wider pH range and consumes far less alkalinity than alum.
Borax
Borax (CAS 1303-96-4) is sodium tetraborate, the buffering and fluxing borate. It is classified as a reproductive toxicant in the EU, which has restricted its consumer use without affecting its industrial position.
Cationic Polyacrylamide (CPAM)
Cationic polyacrylamide, CPAM, is a high molecular weight flocculant that works by bridging rather than charge neutralisation. Its long chains adsorb onto several particles at once and pull them into large, shear-resistant flocs.
Calcium Hydroxide
Calcium hydroxide (CAS 1305-62-0), hydrated or slaked lime, is the cheapest bulk alkali available. It is only slightly soluble, which is precisely what makes lime slurry a self-buffering pH control reagent.
Phosphorus Remover
Phosphorus remover is a metal salt coagulant dosed to precipitate dissolved phosphate out of wastewater. Consent limits are typically set at 1 mg/l or below, which biological treatment alone rarely achieves.
Plant-Based Odour Remover
Plant-based odour remover uses essential oil constituents that bind or chemically neutralise odour molecules rather than covering them with fragrance. It acts immediately, where a microbial product takes days to establish.
Microbial Odour Remover
Microbial odour remover is a bioaugmentation product containing selected bacterial cultures and nutrients. It does not mask odour; the organisms degrade the compounds producing it, so the source is removed rather than covered.
Calcium Chloride
Calcium chloride (CAS 10043-52-4) dissolves with a strong exothermic reaction, releasing heat rather than absorbing it. That is why it melts ice faster than salt and keeps working at far lower temperatures.